Operation process of the coal feeder

　　Coal feederThe operating process of the coal feeder can be divided into the inspection work before starting, the operating methods during the starting process, and the maintenance work after stopping. Next, I will introduce these operating processes one by one to help everyone better understand the coal feeder.

　　Before using the coal feeder, it is necessary to check whether all fasteners are secure and reliable. In addition, check whether there is any looseness between the connecting bolts. If there is looseness or they are not tightened, they need to be tightened before using the reducer. The lubrication oil level should be appropriate, and the lubrication of each lubricating part should be good. These need to be checked carefully. If the lubrication is not appropriate, lubrication oil needs to be applied.

　　In addition, checkCoal feederwhether the connection forming roller guide rail is intact. During the use of the coal feeder, after receiving the corresponding signal, wait for the coal equipment to operate normally, and then press the start button to start the coal feeder during its operation. Everyone needs to observe the operating status of the coal selling equipment at all times, and then observe whether there are any blockages of coal blocks at the discharge port. If any are found, a corresponding signal will be issued, and the coal feeder will stop operating. At the same time, the belt will stop, and the switch will be turned off for processing.

　　During operation, professionals need to determine whether there are any abnormal conditions in the temperature of the reducer and motor. If there are any abnormalities, operation should be stopped to check the corresponding fault causes. After analysis and processing, it can continue to be used; otherwise, it cannot continue production. After receiving the stop signal, everyone needs to press and hold the stop button to stop the mechanical operation. After work, maintenance of the coal feeder should be done.

　　Generally speakingCoal feeder, the structure is relatively reasonable, and the system layout is relatively free and flexible, which can meet the coal supply needs of factories over long distances. It can also be made into a fully enclosed type. However, this type of equipment occupies a large area. If the volume of the coal mine is too large or there are debris, it is very easy to get stuck. Therefore, everyone must pay attention when using it and should not input too large coal mines.

　　After use, the coal feeder needs to be cleaned, and each part should be checked for integrity. At the same time, if it is found that the production efficiency is not high during operation, the specific reasons need to be identified. Then replace some easily worn parts so that it can operate normally in the next production process and improve economic benefits. Today, the usage process ofCoal feederhas been introduced here. I hope this article can help everyone in using the coal feeder.